溧陽酸堿廢氣噴淋塔-適用范圍：煉油廠、橡膠廠、皮革廠、印刷廠、化工廠、中西藥廠、金屬鑄造廠、塑料再生廠、噴涂溶劑、食品加工廠、肉類加工廠、屠宰場、家禽飼料場、造紙廠、污水處理廠、垃圾轉運站等有機和無機物廢氣凈化處理。

Application of the Liyang waste gas spray tower - scope: refinery, rubber factory, leather factory, printing factory, chemical factory, Chinese pharmaceutical factory, metal foundry, plastics recycling plant, spraying solvent, food processing plants, meat processing plants, slaughterhouses and poultry feed, paper mill, sewage treatment plants, garbage transfer stations etc. organic and inorganic waste gas purification.           The working principle of packed spray tower is as follows:           Filler type spray tower is filled with different forms of filler in the spray tower, turning water spray for attached water film on the packing, so as to enhance the contact surface of gas and water, the purifier is especially suitable for exhaust gas containing paint particles. In the spray tower, the exhaust gas enters from the lower part of the tower and is fully contacted with the water film through the packing surface. The tower set the number of rows of nozzles, spray downwards under the action of gravity, in contrast with the exhaust gas flow direction, exhaust air flow through the mist purification to discharge in gas discharge in water will be set before the air drops of water in the trap down, to prevent out of.           The exhaust gas enters into the circulating water tank after the water mist is collected, and then is used after the precipitation and the slag separation treatment. As the waste gas in the washing process will be part of the material dissolved in water, so that the circulation of water in the long run after saturation. At this point should be part of the circulation of water, and to add some fresh water to the pool, so that the circulation of water to maintain a certain degree of absorption. After the replacement of waste water can be recovered by the special recycling agencies, truly zero emissions, water pollution will not produce two times.           Characteristic           1 equipment area is small, easy to install;           2 water consumption, low power consumption indicators;           3 corrosion resistance, no wear, long service life;           4 the equipment is reliable and easy to maintain.           structure           The spray tower filler layer as a component of gas-liquid two phase contact mass transfer equipment. The packing tower with packing support plate, packing to huddle place in the support plate. The filler is installed above the filler plate, in order to prevent rising air blowing. Spray tower spray liquid from the top of the tower by spraying liquid distributor to packing, and the packing surface along the flow. The gas is fed from the bottom of the tower, and is distributed with the liquid through the gas distribution device, and then flows through the gap of the packing layer. When the liquid flows along the packing layer, the wall flow phenomenon sometimes occurs, and the wall flow effect results in the uneven distribution of the gas-liquid two-phase in the packing layer, which leads to the decrease of the mass transfer efficiency. Therefore, the filler layer spray tower is divided into two sections, arranged in the middle of distribution device, the re distribution of spray to lower packing.           Matters needing attention           1, spray tower sedimentation tank to be cleaned regularly, clean up once a week in summer.           2, the rotating parts should always check the oil, and found that failure to promptly eliminate, to ensure the effect of desulfurization spray tower.           3, in the upper and lower stairs when medicine is to Caution!, have independent security, mutual security awareness.           4, the work is completed in a timely manner to clean up the health, so that people go to the venue.           Torgovnik           .